User's Manual

12
Overview of the Cisco LoRaWAN Interface Module
Hardware Features
LEDs
This section describes the LEDs for the Cisco LoRaWAN Interface Module. See Figure 1 on page 9 for the locations of
LED indicators.
Optional Hardware
Depending on what you ordered, the following optional Cisco LoRaWAN Interface Module hardware may be part of your
shipment:
 Wall/pole mount kit (AIR-ACC1530-PMK1=)
 DC-IN power adapter jack plug (PLG-PWRJCK=)
 Grounding lug
 LoRa Antenna
— Omni-directional antenna (ANT-LPWA-DB-O-N=)
— Antennas lightning arrestor (ACC-LA-H-NM-NF=)
— 10-ft low-loss cable assembly with N type connector (AIR-CAB010LL-N=)
 GPS Antenna
— Outdoor GPS antenna with integrated 15-ft cable (ANT-GPS-OUT-TNC=)
— Outdoor GPS antenna lightning arrestor (ACC-LA-G-TM-TF=)
Note: For more detailed information about the accessories, see the data sheet of Cisco LoRaWAN Interface Module.
Table 2 LED Definitions
LED LED Color Definition
System LED (LED 1) Off Power off or under bootloader mode
Blinking green Under the starting kernel (bring up phase)
Solid green Normal operation state
Blinking red  Failed to get IP address
 Register to IR800 failed
Solid red  ACT2 check failed
 Lost connection to IR800
 CPU usage high
 Temperature high
 Flash usage high
 Cover open
Reserved LED (LED 2) Reserved for future use. —