User's Manual

22
Installing the Cisco LoRaWAN Interface Module
Installing Antennas
Figure 3 Cisco LoRaWAN Interface Module and Fixed Mount Kit Installed on a Pole
Installing Antennas
The Cisco LoRaWAN Interface Module is equipped with two N-type radio frequency (RF) connectors (antenna ports 1
and 2) on the top of the unit for LoRa antennas, and one TNC connector on the left of the unit for the GPS antenna, as
shown in Figure 4 on page 24.
The following topics are described in this section:
 Supported Antennas, page 22
 Antenna Connector Locations, page 24
 Connecting the LoRa Antennas, page 24
 Connecting the GPS Antenna, page 26
 Installing a Lightning Arrestor, page 26
Supported Antennas
The following antennas are supported by the Cisco LoRaWAN Interface Module:
1 Metal Band Strap 2 Mounting Slots
3 Pole