User's Manual

33
Installing the Cisco LoRaWAN Interface Module
Powering the Cisco LoRaWAN Interface Module
Figure 10 Inserting RJ-45 Connector into the Ethernet Port Opening in Case
8. Slide the cable gland with the rubber seal towards the Cisco LoRaWAN Interface Module, and screw the threaded
end of the body into the Cisco LoRaWAN Interface Module, and hand-tighten.
9. Use an adjustable wrench or a 28-mm wrench to tighten the threaded end of the body into the enclosure. Tighten
to 15 in-lbs (1.69 N-m).
10. Use an adjustable wrench and tighten the thread-lock seal nut to 15 in-lbs (1.69 N-m).
11. Ensure that the antennas are connected to the Cisco LoRaWAN Interface Module before you apply power to the
Cisco LoRaWAN Interface Module.
12. Route your Ethernet cable, and cut off any excess cable.
13. Install an RJ-45 connector on the unterminated cable end, and insert it into the power injector.
14. Turn on power to the power injector.
Connecting a DC Power Cable to the Cisco LoRaWAN Interface Module
When powering the Cisco LoRaWAN Interface Module with DC power, you must ensure that DC power can be
conveniently removed at the source.
1 Ethernet port opening in Cisco LoRaWAN Interface Module case. Also see Figure 15 on page 38.
2 RJ-45 connector, on shielded outdoor-rated Ethernet (CAT5 or better) cable
3 Exploded view of the cable gland, on the Ethernet cable.
4 DC power opening in Cisco LoRaWAN Interface Module case. Also see Figure 15 on page 38.
5 Exploded view of the cable gland on the DC power cable.