User's Manual

35
Installing the Cisco LoRaWAN Interface Module
Powering the Cisco LoRaWAN Interface Module
Figure 11 Cisco LoRaWAN Interface Module DC Power Connector
4. Loosen the thread-Lock sealing nut of the cable gland by turning it counter clockwise, but do not remove (see
Figure 12 on page 35).
Verify that the cable gland has a rubber seal and ensure that it is not damaged.
Warning: Failure to install the Cable Gland properly will cause the cable grip to leak.
Figure 12 Cable Gland
Note: The cable gland accepts a cable diameter of 0.43 to 0.65 cm.
1 Pressure vent 3 PoE-in port
2 DC power port 4 LED indicators
1 Washer (Rubber Gasket) 2 Body
3 Sealing insert 4 Clamping claw
5 Thread-lock sealing nut