User's Manual

15
Getting Started and Product Document of Compliance for the Cisco LoRaWAN Interface Module
Grounding the Device
Grounding the Device
Make sure to follow any grounding requirements at your site.
Warning: This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an
electrician if you are uncertain that suitable grounding is available. Statement 1024
Warning: Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning: The equipment has a separate protective earthing terminal on the chassis that must be permanently connected
to the earth ground to adequately ground the chassis and protect the operator from electrical hazards.
Caution: Before equipment installation begins, ensure that a service personnel has attached an appropriate grounding
lug to the grounding cable that you supply.
Caution: Power installation must be performed with qualified electrician and followed with National Electrical Code,
ANSI/NFPA 70 and Canadian Electrical Code, Part I, CSA C22.1.
To connect earth ground to the unit:
1. Connect one end of the grounding cable to a proper earth ground.
2. Place the grounding lug attached to the grounding cable over the protective earthing terminal.
3. Secure the grounding lug to the protective earthing terminal with the washers and screws.
4. Dress the grounding cable and ensure that it does not touch or block access to other components.
Warning: Before the device is powered on, connect the frame of the unit to the earth.
Warning: For the earthing wire, green-and-yellow insulation is required and the cross-sectional area of the conductor
must be more than 0.75mm
2
or 26 AWG.
Warning: The product shall be installed by a qualified service person and the installation shall conform to all local codes.
Regulatory Compliance and Safety Information
Declarations of Conformity and Regulatory Information
For the declarations of conformity and regulatory information for the Cisco LoRaWAN Interface Module, see the Cisco
LoRaWAN Interface Module Hardware Installation Guide.
For EMC and safety information, see the Regulatory Compliance and Safety Information at this URL:
http://www.cisco.com/go/lorawanmodule