User's Manual

7
Getting Started and Product Document of Compliance for the Cisco LoRaWAN Interface Module
Becoming Familiar With the Device
Figure 2 Cisco LoRaWAN Interface Module Top and Left Panels
Antennas
The Cisco LoRaWAN Interface Module is equipped with two N-type radio frequency (RF) connectors (antenna ports 1
and 2) on the top of the unit for LoRa antennas, and one TNC connector on the left of the unit for the GPS antenna, as
shown in Figure 3 on page 8. The LoRa antennas should be connected to the chassis via an appropriate low-loss RF coax
cable, for the Cisco LoRaWAN Interface Module to work properly. The LoRa antennas should be installed closely to the
Cisco LoRaWAN Interface Module to reduce the signal strength loss on the feed cable as much as possible.
Note: The antennas can't be directly installed on the unit without a cable.
For detailed information on the antenna installation options, see the Cisco LoRaWAN Interface Module Hardware
Installation Guide.
Refer to the data sheet for the antenna specifications.
Note: The antenna port caps must be removed before using, but the unused ports should remain capped to provide an
IP67 seal. All port or antenna connection must be terminated by an IP67 rated cap or cable.
FCC Caution
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter, except the
collocation in accordance with FCC multi-transmitter product guidelines.
Radiation Exposure Statement
This equipment complies with FCC and ISED radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 23 cm between the radiator and your body.
1 LoRa antenna ports 2 Ground lug location
3 GPS antenna port