User's Manual

8
Getting Started and Product Document of Compliance for the Cisco LoRaWAN Interface Module
Becoming Familiar With the Device
Déclaration d'exposition aux radiations
Cet équipement est conforme aux limites d'exposition aux rayonnements ISED établies pour un environnement non
contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 23 cm de distance entre la source de
rayonnement et votre corps.
Figure 3 Antenna Connectors
Antenna Mounting Configurations
The selection of the antenna is determined in the configuration of the product. The antennas can be mounted on a wall,
pole and/or tower mounted.
The antennas must be installed at half a wavelength apart from each other.
Note: The FCC limits the amount of power this device can transmit. Power transmitted is a combination of the
amplification of the signal and the antenna gain. The Cisco LoRaWAN Interface Module has been designed to operate
with the Cisco provided antennas.
Power
Note: For detailed information on the power options available for the Cisco LoRaWAN Interface Module, see the
Cisco LoRaWAN Interface Module Hardware Installation Guide.
Warning: Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning: This equipment must be externally grounded using a customer-supplied ground wire before power is
applied. Contact the appropriate electrical inspection authority or an electrician if you are uncertain that suitable
grounding is available. Statement 366
Warning: Do not work on the system or connect or disconnect cables during periods of lightning activity. Statement
1001
The Cisco LoRaWAN Interface Module supports these power sources:
 Power-over-Ethernet (PoE+, 30W)
1 TNC connector for GPS antenna 2 N-Type connectors for LoRa antennas