User's Manual

9
Getting Started and Product Document of Compliance for the Cisco LoRaWAN Interface Module
Pole/Wall Mounting
 DC power—48 VDC
Caution: Do not place the power injector in an unprotected outdoor environment because water could get into the power
injector and cause a short circuit and possible fire.
Warning: Connect the unit only to DC power source that complies with the Safety Extra-Low Voltage (SELV)
requirements in IEC 60950 based safety standards Statement 1033
Ethernet (PoE+) Ports
The Cisco LoRaWAN Interface Module supports an Ethernet uplink port (PoE-In). The RJ-45 connector (with
weatherproofing) links the device to the 10BASE-T or 100BASE-T network. The Ethernet cable is used to send and
receive Ethernet data and to optionally supply inline 56-VDC power from the power injector.
Warning: To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord.
Statement 1023
The Ethernet cable must be a shielded outdoor rated Category 5 (CAT5) or better cable. The Cisco LoRaWAN Interface
Module senses the Ethernet and power signals and automatically switches internal circuitry to match the cable
connections.
LEDs
This section describes the LEDs for the Cisco LoRaWAN Interface Module. See Figure 1 on page 6 for the locations of
LED indicators.
Pole/Wall Mounting
Note: For more installation options and detailed installation instructions, see the Cisco LoRaWAN Interface Module
Hardware Installation Guide.
The Cisco LoRaWAN Interface Module can be pole or wall mounted by using the mounting kit (AIR-ACC1530-PMK1=).
Table 2 LED Definitions
LED LED Color Definition
System LED (LED 1) Off Power off or under bootloader mode
Blinking green Under the starting kernel (bring up phase)
Solid green Normal operation state
Blinking red  Failed to get IP address
 Register to IR800 failed
Solid red  ACT2 check failed
 Lost connection to IR800
 CPU usage high
 Temperature high
 Flash usage high
 Cover open
Reserved LED (LED 2) Reserved for future use. —