ATM Switch Installation Guide

2-4 Cisco LightStream 100 User Guide

Installation Environmental Conditions

Install the LightStream 100 ATM switch in an area that meets the following conditions:

1 Make sure the LightStream 100 switch remains operational within the temperature and

humidity limits shown in Table 1-3.

2 Allow the following minimum vacant space surrounding the LightStream 100 switch to

ensure proper heat radiation:

— 10 cm (approximately 4 inches) or more—sides

— 10 cm (approximately 4 inches) or more—front and rear

— 10 cm (approximately 4 inches) or more—top

3 Make sure the installation site meets the following criteria:

— Protected from water and chemicals

— Free of shock and vibration

— Horizontal

— Free of excessive dust

— Away from direct sunlight

— Away from devices that generate strong magnetism (for example, a TV or speakers)

Conﬁrming the Contents of the Shipping Container

This section provides information about the contents of containers used to transport the

LightStream 100 ATM switch.

The LightStream 100 switch comes in two containers: the LightStream 100 main unit

container and the LINF card container. Ensure that the containers are labeled with each type

of equipment before opening them.

The LightStream 100 main unit includes the following parts:

• Motherboard (P-8X84)

• Bus converter (BCONV) card (P-8X54)