User Manual

Us ing the Module
The Meraki Mini Module comes pre-installed with Meraki Mesh firmware. The following
steps describe how to install the Meraki Mini Module as part of a network.
1. Connect an antenna to the RP-SMA antenna port. The Meraki Mini Module is
certified for use with omni-directional antennas with 5dBi or less gain.
2. Apply power to the Meraki Mini Module, using either a DC adapter or
compatible Power-over-Ethernet adapter. Note: the Meraki Mini Module uses a
non-standard voltage of 4.5-18V. Check that the power indicator LED on the
Ethernet connector is lit.
3. Allow the device to boot for one minute.
4. Connect a computer to the module to complete configuration. You can either
use the Ethernet interface by connecting a standard RJ-45 Ethernet connector, or
connect to the device using an 802.11 client adapter. The preconfigured SSID is
“ meraki” .
5. Once connected, use a web browser to view the local connection statistics by
visiting http://192.168.85.1/. If the signal is weak, consider repositioning the
device to improve signal quality.