User's Manual

 Power-over-Ethernet support (non-802.3af)
Using the Module
The Meraki Outdoor Module comes pre-installed with Meraki Mesh firmware. The
following steps describe how to install the Meraki Outdoor Module as part of a network.
1. Connect the antenna to the RP-SMA antenna port.
2. Apply power to the Meraki Outdoor Module, using either a DC adapter or
compatible Power-over-Ethernet adapter. Note: the Meraki Outdoor Module
uses a non-standard voltage of 5-22V.
3. Allow the device to boot for one minute.
4. Connect a computer to the module to complete configuration. You can either
use the Ethernet interface by connecting a standard RJ-45 Ethernet connector,
or connect to the device using an 802.11 client adapter. The preconfigured
SSID is “meraki”.
5. Once connected, use a web browser to view the local connection statistics by
visiting http://192.168.85.1/. If the signal is weak, consider repositioning the
device to improve signal quality.