Network Router User Manual
Table Of Contents
- Rules for Adding a DAX Connection
- Rules for Adding Three-Segment Connections
- Rules for Adding Management Connections
- BPX 8600-to-BPX 8600 Segment
- Very High Speed Frame Service Modules
- Eight-Port Channelized and Unchannelized Frame Service Module
- Four-Port Unchannelized Frame Service Module for V.35
- MGX-FRSM-2CT3 Features
- MGX-FRSM-2T3E3 Features
- MGX-FRSM-HS2/B Features
- MGX-FRSM-HS1/B Features
- Eight-Port FRSM Features
- Congestion Indication for NIW Connections
- PVC Status Management
- Cell Loss Priority
- Congestion Indication
- Command and Response Mapping
- Translation and Transparent Modes
- Loss Priority Indication
- Congestion Indication
- Cell Delay Treatment
- Error and Alarm Response
- Configuring the Card, Lines, and Ports
- Adding and Modifying Connections
- Configuring the Card, Lines, and Ports
- Configuring Bulk Distribution and Redundancy
- Adding and Modifying Connections
- Configuring Redundancy Through the Redundancy Bus
- Configuring Redundancy Through the Distribution Bus
- Pattern Test Options
- Loopback Test Options
Card and Service Configuration 6-17
Adding and Configuring Connections on the AUSM/B
cnfupcubr <port.vpi.vci> <enable> <pcr[0+1]> <cdvt[0+1]> <IngPc> <util> <clp_tag>
Step 3 If the system has the ForeSight feature, use cnfchanfst to configure it.
cnfchanfst <port.vpi.vci> <enable> <fgcra_enable> <ibs> <pcr> <mcr> <icr>
port.vpi.vci identifies the connection.
enable is the enabled/disable for UPC: 1=Disable, 2=Enable.
pcr is the peak cell rate. Without IMA, the range is:
T1, 10–3622
E1, 10–4528
clear E1, 10–4830
For IMA, multiply the line rate by the number of links.
cdvt cdvt[0+1] is the cell delay variation tolerance for cells with
CLP=[0+1]. The range is 1–250000 micro seconds.
scr is the peak cell rate. Without IMA, the range is:
T1, 10–3622
E1, 10–4528
clear E1, 10–4830
For IMA, multiply the line rate by the number of links.
scr_police specifies the type of scr policing: 1= CLP[0] Cells,
2=CLP[0+1] cells, and 3=no SCR policing.
mbs is the maximum burst size: the range is 1–5000 cells.
IngPc is the percent utilization on the ingress. The range is 1–127. The
default is 0.
hclp_tag is the enable for CLP tagging: 1=disable, 2=enable.
port.vpi.vci identifies the connection.
enable is the enabled/disable for the ForeSight feature:
1=disable, 2=enable.
fgcra_enable is the enabled/disable for the frame-based generic cell rate
algorithm: 1=disable, 2=enable.
ibs is the initial burst size in the range 0–5000 cells.
pcr is the peak cell rate. Without IMA, the range is:
T1, 10–3622
E1, 10–4528
clear E1, 10–4830
For IMA, multiply the line rate by the number of links.