User Manual
Table Of Contents
- Permissions, trademarks, and distribution
- Regulatory Information
- Safety
- Introduction
- Ripwave Unit Installation
- Ripwave Monitor Software Installation
- Accessing the Internet
- Ripwave Unit Indicator Lights
- Displaying the Ripwave Monitor
- Uninstall Ripwave Software
- Installing / Charging the Battery
- Beta User Guide Frequently Asked Questions
- End User License Agreement
Ripwave 2.6 GHz User Guide Navini Networks, Inc.
4. Connect the AC power adapter cable
to the Ripwave unit. Plug the other
end of the AC power adapter cable
into a 110 VAC outlet.
Caution: Only use the
AC power adapter supplied with the
Ripwave unit. Using any other adapter
may cause damage to the Ripwave Unit.
AC Power
adapter cable
j
ack
5. Push the On/Off switch
on the Ripwave unit to turn the
unit ON.
USB Port
6. If the green power-indicator light is
on, proceed to step 7. If the green
power-indicator light is not on, there
is a problem with the Ripwave unit
or the AC Power Adapter. Check all
cables for proper connection.
Otherwise, contact the supplier
from whom you obtained
the package.
Power on indicator
On/Off switch
7. Set the power switch on the computer to the ON position. When the system is up,
log in to the computer.
8. Proceed to the Ripwave Monitor Software Installation on page 9.
8