User Manual
Table Of Contents
- Permissions, trademarks, and distribution
- Regulatory Information
- Safety
- Introduction
- Ripwave Unit Installation
- Ripwave Monitor Software Installation
- Accessing the Internet
- Ripwave Unit Indicator Lights
- Displaying the Ripwave Monitor
- Uninstall Ripwave Software
- Installing / Charging the Battery
- Beta User Guide Frequently Asked Questions
- End User License Agreement
Ripwave 2.6 GHz User Guide Navini Networks, Inc.
Ripwave Monitor Software Installation
Notes:
For Windows NT
®
and Windows
®
2000, you must be logged into an account
having administrative privileges to install the Ripwave monitor software.
For Ripwave monitor software installation on Windows
®
95, Windows
®
98, and
Windows
®
98SE Operating Systems, the operating system CD will be needed to
complete the installation. If prompted, insert the operating system CD in the
CD-ROM drive and accept the defaults.
Installation procedures:
The following instructions are for installing the software that monitors the operation and
performance of the Ripwave unit.
1. Shut down all programs before installing the Ripwave monitor software. This
includes all anti-virus software.
2. Insert the Navini Networks Ripwave installation CD in the CD-ROM drive.
3. Click Start > Run at the bottom left corner of your screen. In the Run window,
enter e:\setup (where “e” represents the CD drive; use the letter representing your
specific CD drive) in the Open field. Click OK to continue.
9