User's Manual
Table Of Contents
- Permissions, trademarks, and distribution
- Regulatory Information
- Safety
- Introduction
- Ripwave Unit Installation
- Ripwave Monitor Software Installation
- Accessing the Internet
- Ripwave Unit Indicator Lights
- Displaying the Ripwave Monitor
- Uninstall Ripwave Monitor Software
- Installing / Charging the Battery
- Beta User Guide Frequently Asked Questions
- End User License Agreement
Ripwave 2.6 GHz User Guide Navini Networks, Inc.
Ripwave Unit Installation
USB connections
The following instructions are for the installation of the Ripwave Unit model 2600U using a
USB connection. Please read all instructions before attempting installation. It is recommended
that the computer and the Ripwave unit be turned off before performing the installation.
1. Connect the USB cable
to the USB port on the
computer as shown.
2. Connect the other end of the
USB cable to the
Ripwave unit as shown.
AC Power
adapter cable
j
ac
k
3. Connect the AC power adapter
cable to the Ripwave unit.
Plug the other end of the AC
power adapter cable
into a 110 VAC outlet.
Caution: Only use the
AC power adapter supplied
with the Ripwave unit. Using
any other adapter may cause
damage to the Ripwave Unit.
USB Port
2