User's Manual
Table Of Contents
- Permissions, trademarks, and distribution
- Regulatory Information
- Safety
- Introduction
- Ripwave Unit Installation
- Ripwave Monitor Software Installation
- Accessing the Internet
- Ripwave Unit Indicator Lights
- Displaying the Ripwave Monitor
- Uninstall Ripwave Monitor Software
- Installing / Charging the Battery
- Beta User Guide Frequently Asked Questions
- End User License Agreement
Ripwave 2.6 GHz User Guide Navini Networks, Inc.
4. Rotate the antenna on the
Ripwave unit clockwise
180 degrees to the ‘UP’ position.
This reveals the Ripwave
indicator lights.
Caution: Rotation or movement
of the antenna in any other
direction may cause
damage to the Ripwave Unit.
Rotate
antenna
clockwise
180 degrees
Signal Strength Indicator
Battery Indicator
P
owe
r In
d
i
cator
5. Push the On/Off switch
on the Ripwave unit to turn the
unit ON.
6. If the green power-indicator light is
on, proceed to step 7. If the green
power-indicator light is not on, there
is a problem with the Ripwave unit
or the AC Power Adapter. Check all
cables for proper connection.
Otherwise, contact the supplier
from whom you obtained
the package.
Power on indicator
On/Off switch
7. Set the power switch on the computer to the ON position. When the system is up, log in
to the computer.
8. Proceed to the Ripwave Monitor Software Installation on page 9.
8