User's Manual
Table Of Contents
- Permissions, trademarks, and distribution
- Regulatory Information
- Safety
- Introduction
- Ripwave Unit Installation
- Ripwave Monitor Software Installation
- Accessing the Internet
- Ripwave Unit Indicator Lights
- Displaying the Ripwave Monitor
- Uninstall Ripwave Monitor Software
- Installing / Charging the Battery
- Beta User Guide Frequently Asked Questions
- End User License Agreement
Ripwave 2.6 GHz User Guide Navini Networks, Inc.
Installing / Charging the Battery
Note: The battery is an option and is not included with the unit.
The battery is installed in the bottom of the Ripwave unit. To install and charge the battery,
follow the steps below.
1. Using the battery pack tab, remove the battery cover from the Ripwave unit.
Battery pack tab
2. Install the battery pack into the Ripwave unit, ensuring that the contacts on the battery
pack mate with the contacts in the Ripwave unit.
Battery contacts
Battery pack contacts
21