User manual
Table Of Contents
- Notice à l’attention des installateurs de réseaux câblés
- Mitteilung für CATV-Techniker
- Aviso a los instaladores de sistemas CATV
- IMPORTANT SAFETY INSTRUCTIONS
- Power Source Warning
- Ground the Product
- Protect the Product from Lightning
- Verify the Power Source from the On/Off Power Light
- Eliminate AC Mains Overloads
- Handling Disposable Batteries
- Provide Ventilation and Select a Location
- Protect from Exposure to Moisture and Foreign Objects
- Service Warnings
- Check Product Safety
- Protect the Product When Moving It
- Telephone Equipment Notice
- United States FCC Compliance
- CE Compliance
- About This Guide
- Introducing the DOCSIS Cable Modem
- Installing the DOCSIS Cable Modem
- Installation Preparations
- Install the Cable Modem
- Operation of Front Panel Indicators
- Maintaining the Battery
- Troubleshooting the DOCSIS Cable Modem
- Frequently Asked Questions
- How Do I Configure TCP/IP Protocol?
- How Do I Renew the IP Address on My PC?
- What if I Don't Subscribe to Cable TV?
- How Do I Arrange for Installation?
- How Does the Cable Modem Connect to My Computer?
- After My Cable Modem Is Connected, How Do I Access the Internet?
- Can I Watch TV and Surf the Internet at the Same Time?
- Can I Use my Existing Phone Number with the Cable Modem?
- How Many Telephones Can I Connect?
- Common Troubleshooting Issues
- Tips for Improved Performance
- Frequently Asked Questions
- Customer Information
- Index
Chapter 3 Operation of Front Panel Indicators
24 4027620 Rev A
Normal Operations (AC Power Applied)
The following chart illustrates the appearance of the cable modem front panel LED
status indicators during normal operations when AC power is applied to the
gateway.
Front Panel LED Status Indicators During Normal Conditions
Front Panel Indicator
Normal Operations
1
POWER
On
2
DS
On
3
US
On
4
ONLINE
On
5
LINK
On - When the wireless access point is enabled and
operational
Blinks - When data is being transferred between the CPE
and the wireless home gateway
Off - When the wireless access point is disabled by the
user
6
TEL 1
On - When telephony service is enabled
Blinks - When line 1 is in use
7
TEl 2
On - When telephony service is enabled
Blinks - When line 2 is in use
8
BATTERY
On - When battery is charged
Blinks - When battery charge is low
Off - When there is no battery in the unit
Note: In addition to the status shown in the previous table, some service providers
use color-coded LEDs to indicate detailed channel bonding and data link status. For
additional information about color-coded LEDs, check with your service provider.