user manual

3-106
Cisco 7600 Series Router MIB Specifications Guide
OL-4077-07
Chapter 3 Cisco 7600 MIB Specifications
MPLS-LDP-MIB
MIB Constraints
Table 3-32 lists the constraints that the Cisco 7600 Series router places on objects in the
MPLS-LDP-MIB. For detailed definitions of MIB objects, see the MIB.
Table 3-32 MPLS-LDP-MIB Constraints
MIB Object Notes
mplsLdpGeneralGroup
•
mplsLdpLsrId Read-only.
• mplsLdpLsrLoopDetectionCapable Read-only. Loop Detection is supported by
hopCountAndPathVector(5).
• mplsLdpEntityIndexNext Read-only. Returns a value of 0.
mplsLdpEntityTable
•
mplsLdpEntityProtocolVersion Read-only.
• mplsLdpEntityAdminStatus Read-only. If adjacency is directed, value is
always enabled(1).
• mplsLdpEntityOperStatus Read-only. If adjacency is directed, then the
operation status is always enabled(1). The
adjacency does not appear in this table if
operation status is down.
• mplsLdpEntityTcpDscPort Read-only.
• mplsLdpEntityUdpDscPort Read-only.
• mplsLdpEntityMaxPduLength Read-only.
• mplsLdpEntityKeepAliveHoldTimer Read-only.
• mplsLdpEntityHelloHoldTimer Read-only.
• mplsLdpEntityInitSesThreshold Read-only. Default value is 8.
• mplsLdpEntityLabelDistMethod Read-only.
• mplsLdpEntityLabelRetentionMode Read-only. If LC-ATM then values are
conservative(1) otherwise liberal(2). If
directed, then the value is liberal(2).
• mplsLdpEntityPVLimitMisTrapEnable Read-only.
• mplsLdpEntityPVL Read-only.
• mplsLdpEntityHopCountLimit Read-only.
• mplsLdpEntityTargPeer Read-only.
• mplsLdpEntityTargPeerAddrType Read-only. Value is ipv4(1).
• mplsLdpEntityTargPeerAddr Read-only.
• mplsLdpEntityOptionalParameters Read-only. If LC-ATM, then values are
atm(2), otherwise generic(1). If directed,
then the value is generic(1).
• mplsLdpEntityDiscontinuityTime Read-only.
• mplsLdpEntityStorType Read-only. Value is volatile(2).
• mplsLdpEntityRowStatus Read-only. Value is active(1).