user manual

3-108
Cisco 7600 Series Router MIB Specifications Guide
OL-4077-07
Chapter 3 Cisco 7600 MIB Specifications
MPLS-LDP-ATM-STD-MIB (RFC 3815)
MPLS-LDP-ATM-STD-MIB (RFC 3815)
The MPLS-LDP-ATM-STD-MIB (RFC 3815) contains managed object definitions for configuring and
monitoring the Multiprotocol Label Switching (MPLS), Label Distribution Protocol (LDP), utilizing
Asynchronous Transfer Mode (ATM) as the Layer 2 media.
• mplsLdpSesState Read-only.
• mplsLdpSesProtocolVersion Read-only.
• mplsLdpSesKeepAliveHoldTimeRem Read-only.
• mplsLdpSesMaxPduLen Read-only.
• mplsLdpSesDiscontinuityTime Read-only.
mplsLdpAtmSesTable
Not implemented. Cisco 7600 does not
support LC-ATM enabled interfaces
mplsLdpFrameRelaySesTable
Not implemented.
mplsLdpSesStatsTable
•
mplsLdpSesStatsUnkMesTypeErrors Read-only.
• mplsLdpSesStatsUnkTlvErrors Read-only.
mplsFecTable
Not implemented.
mplsFecIndexNext
Not implemented.
mplsLdpSesInLabelMapTable
Not implemented.
mplsLdpSesOutLabelMapTable
Not implemented.
mplsLdpSesXCMapTable
Not implemented.
mplsXCsFecsTable
Not implemented.
mplsLdpSesPeerAddrTable
Not implemented.
Important information about using the MPLS-LDP-MIB:
The mplsLdpEntityTable is used to configure the LSR for using LDP. There must be at least one LDP entity for the LSR to
support LDP. Each row in this table refers to a single LDP entity.
Entries in the mplsLdpEntityConfGenericTable refer to configured Generic Labels on LDP entities. An LDP entity can have
zero or more generic labels.
The mplsLdpEntityFrameRelayParmsTable contains Frame Relay specific information and parameters for LDP entities. The
mplsLdpEntityConfFrLRTable provides a mechanism for specifying a range of DLCI values, or a label range for LDP
entities.
The mplsLdpEntityStatsTable enhances the mplsLdpEntityTable and contains statistics about the LDP entities in the LSR.
The mplsLdpEntityPeerTable contains information about LDP peers in the mplsLdpEntityTable. This information is
based on information gathered through Entity-Peer interaction.
The mplsLdpSessionTable represents a table of sessions between LDP entities and LDP peers and contains information about
these sessions. The mplsHelloAdjacencyTable is a table of Hello Adjacencies for Sessions. A session can have one or
more Hello Adjacencies. The mplsLdpFrameRelaySessionTable relate Sessions to its label range intersections. The
mplsLdpSessionStatsTable augments the mplsLdpSessionTable and contains statistics about each Session between a
LDP entities and a LDP peer. The mplsLdpSesPeerAddressTable extends the mplsLdpSessionTable and is used to store
Label Address Information from Label Address Messages received by this LSR from Peers.
The Cisco 7600 router does not support LC-ATM (label-controlled) interfaces.
Table 3-32 MPLS-LDP-MIB Constraints (continued)
MIB Object Notes