user manual

3-112

Cisco 7600 Series Router MIB Specifications Guide

OL-4077-07

Chapter 3 Cisco 7600 MIB Specifications

MPLS-LSR-STD-MIB (RFC 3031)

The MPLS-LSR-STD-MIB (RFC 3031) contains managed object definitions for the Multiprotocol Label

Switching (MPLS) Router.

MPLS-L3VPN-STD-MIB

The MPLS-L3VPN-STD-MIB contains managed object definitions for the Layer-3 Multiprotocol Label

Switching Virtual Private Networks. This MIB is based on RFC 4382 specification.

MPLS-TC-MIB

The MPLS-TC-MIB defines Textual Conventions and OBJECT-IDENTITIES for use in documents

defining management information bases (MIBs) for managing MPLS networks.

MPLS-TE-MIB

The MPLS-TE-MIB enables the Cisco 7600 Series router to perform traffic engineering for MPLS

tunnels. The MIB is based on Revision 05 of the IETF MPLS-TE-MIB.

Traffic engineering support for MPLS tunnels requires the following configuration:

• Setting up MPLS tunnels with appropriate configuration parameters.

• Configuring tunnel loose and strict source routed hops.

MIB Constraints

Table 3-34 lists the constraints that the Cisco 7600 Series router places on objects in the

MPLS-TE-MIB. For detailed definitions of MIB objects, see the MIB.

Table 3-34 MPLS-TE-MIB Constraints

MIB Object Notes

mplsTunnelIndexNext Read-only. Always 0.

mplsTunnelTable

•

mplsTunnelName Read-only.

• mplsTunnelDescr Read-only.

• mplsTunnelIsif Read-only.

• mplsTunnelXCPointer Read-only.

• mplsTunnelSignallingProto Read-only.

• mplsTunnelSetupPrio Read-only. Always 7.

• mplsTunnelHoldingPrio Read-only. Always 7.

• mplsTunnelSessionAttributes Read-only.