Installation Manual

CiscouBR7200 Series Universal Broadband Router Wireless Modem Card and Subsystem Installation and Configuration 25

Configuring a Wireless Modem Card

ALPHA DRAFT - CISCO CONFIDENTIAL

Configuring a Wireless Modem Card

After you have installed or replaced a wireless modem card, you must use the Cisco IOS software

command-line interface (CLI) to configure the modem card for correct operations of the card and

wireless subsystems. The commands for login and completing the configuration are described in this

section. Commands are also provided to enable you to verify the individual tasks in the configuration

process.

NoteYou must perform a basic configuration of the CiscouBR7200 series router before

configuring the wireless modem cards. refer to the CiscouBR7200 Series Universal Broadband

Router Installation and Configuration Guide publication that shipped with your CiscouBR7246 or

CiscouBR7223 for more information.

Syntax Conventions

The following conventions are used in the:

NoteAll examples in the following sections use the hostname of WMCS01.

Use the steps in Table6 to login and start the configuration process.

NoteSome commands require privileged configuration access privileges. These commands are

marked “Privileged configuration access is required”.

Convention Meaning

command-name The actual CLI command

<replaceable parameters> A parameter that the user needs to substitute to identify the object of interest.

[optional parameter] A parameter that need not be specified. If specified it will qualify the command for the

specified subset.

keyword A keyword that has significance in the context it is being used.

{choice1 | choice2} Represents the set of choices, one of which must be specified

(detail1, detail2) Details displayed by the CLI in response to a show command