Installation Manual

26CiscouBR7200 Series Universal Broadband Router Wireless Modem Card and Subsystem Installation and Configuration
Configuring a Wireless Modem Card
ALPHA DRAFT - CISCO CONFIDENTIAL
show controllers
Use this command to display all or a subset of attributes of a particular modem card. If none of the
options are specified, all the hardware subsystem(s) information will be displayed. Commonly
displayed parameters are shown in the "Display Elements" section. Actual output parameters depend
on the hardware and implementation. Privileged configuration access is required.
Unless an error occurs, no notifications are displayed on the console.
show controllers radio <slot number>/<port number> [{if | rf | fir | codec | dsp | arq | pci | phy
| driver}]
Table6 Login Steps
Step Command Purpose
1
WMCS01(boot)>
enable
Password: <password>
WMCS01(boot)#
Enter Exec mode.
Enter the password.
You are in Exec mode when the prompt changes
to
WMCS01(boot)#.
2
WMCS01(boot)#
configure terminal
password: <password>
WMCS01(boot)(config)#
Enter Privileged Configuration mode.
Enter the Privileged Configuration password.
You are in this mode when the prompt changes to
WMCS01(boot)(config)#.
3 WMCS01(boot)(config)# interface radio 3/0
WMCS01(boot)(config-if)#
Enter Interface Configuration mode for the
specified modem card.
You are in this mode when the prompt changes to
WMC01(boot)(config-if)#