Installation Manual
CiscouBR7200 Series Universal Broadband Router Wireless Modem Card and Subsystem Installation and Configuration 45
cable-loss
ALPHA DRAFT - CISCO CONFIDENTIAL
NoteMaximum transmission power is limited by the hardware and the operating band. For the
MMDS band, the maximum average transmit power is 2 Watts (+33 dBm). For the UNII band, the
maximum average transmit power is 100 milliwatts (+20 dBm).
Use the no version of the command to reset the parameters to the defaults.
NoteUse the show running-configuration<interfaceSpec> command to display the current
setting.
Unless an error occurs, no notifications are displayed on the console.
radio transmit-power <power>
no radio transmit power
Syntax Description
Example
The following example sets the transmit power to 25dBm.
WMCS01(boot)(config-if)# radio transmit-power 25
cable-loss
Use this command to adjust the effective cable loss parameter (measured in dB) on the modem card
to compensate for the measured cable loss for the cable connecting the modem card to the ODU.
Privileged configuration access is required.
NoteThe cable loss parameter cannot be set to a value greater than 16dB.
Use the no version of the command to reset the cable loss parameters to the default.
NoteUse the show running-configuration<interfaceSpec> command to display the current
setting.
Unless an error occurs, no notifications are displayed on the console.
radio cable-loss <positive number>
no radio cable-loss
Example
The following example adjusts the effective cable loss parameter to 12dB.
WMCS01(boot)(config-if)# radio cable-loss 12
power Positive number representing power stated in dBm.