Installation Manual

56CiscouBR7200 Series Universal Broadband Router Wireless Modem Card and Subsystem Installation and Configuration
Configuring a Wireless Modem Card
ALPHA DRAFT - CISCO CONFIDENTIAL
Example
The following example shows details of the histogram Constellation Variance specification
configured for the modem card in slot 3, port 0 of the uBR, for DSP 3.
WMCS01(boot)(config-if)# show interfaces radio 3/0 histspec constV dsp 3
ClassconstVarience
Resource Id2
Start Bin Value80
Bin Delta50
Number of Bins20
Update Rate10
Collection duration100
Bit Shift16
Tone Selectionaverage
Dsp Number3
Periodic Sumtrue
Default Histfalse
show interfaces (histdata)
Use this command to display the collected histogram data for the identified histogram specification.
The values are displayed as a BinID:Value pair. BinId represents the sample value contained in that
bin. Value represents the count in the histogram bin.
Unless an error occurs, no notifications are displayed on the console.
show interfaces radio <slot/port> histData <statparam> <antenna_num> dsp <dspnum>