Installation Manual

CiscouBR7200 Series Universal Broadband Router Wireless Modem Card and Subsystem Installation and Configuration 67
show interfaces (arq)
ALPHA DRAFT - CISCO CONFIDENTIAL
show interfaces (arq)
Use this command to display the current ARQ configuration on the modem card.
Unless an error occurs, no notifications are displayed on the console.
show interfaces radio <slot/port> arq
Syntax Description
Display Elements
Example
The following command will display the ARQ configuration for the modem card in slot 3, port 0.
WMCS01(boot)(config-if)# show interfaces radio 3/0 arq
(Display TBD)
loopback
Use this command to configure the specified module to loopback its data path at the specified
subsystem. If no optional parameters are specified, a local IF loopback is established. Privileged
configuration access is required.
Use the no form of the command to remove the loopback specification.
Unless an error occurs, no notifications are displayed on the console.
radio loopback [local <module>]
no radio loopback [local<module>]
slot Positive integer representing the CiscouBR7200 series slot number.
port Positive integer representing the port number on that slot.
pctBW The maximum percent link bandwidth being used for ARQ.
dataLatency Hardware will restrict the maximum latency for packet data to this value.
BurstSize Currently configured burst size.
OnOff Whether ARQ is turned on or off.
ARQPeakBitRate The maximum possible peak bit rate that the link can handle given the current
channel-parameter and ARQ settings.
ARQMinBitRate The minimum bit rate that may be seen on the link given the current
channel-parameter and ARQ settings.
ARQMaxLatencyJitter The Maximum jitter expected on this link given the current configuration.