Installation Manual

68CiscouBR7200 Series Universal Broadband Router Wireless Modem Card and Subsystem Installation and Configuration
Configuring a Wireless Modem Card
ALPHA DRAFT - CISCO CONFIDENTIAL
Syntax Description
Example
The following example initiates a local RF loopback
WMCS01(boot)(config-if)# radio loopback local rf
show interfaces (loopback)
Use this command to display the set of loopbacks currently in effect for the specified modem card.
Unless an error occurs, no notifications are displayed on the console.
show interfaces radio <slot>/<port> loopback
Syntax Description
Example
The following example displays the set of loopbacks currently in effect for the modem card in slot
3, port 0 of the uBR.
WMCS01(boot)(config-if)# show interfaces radio 3/0 loopback
(display TBD)
privacy
Use these commands to configure the baseline encryption options provided by the wireless modem
card. The radio designated as the master radio controls privacy authorization and encryption key
distribution. The radio designated as the slave radio tracks the master radio’s signals. The default is
on. Privileged configuration access is required.
Use the enable command to enable baseline privacy options. Use the other commands to configure
timeout values. When privacy is enabled, the timeout values determine how long the master or the
slave radio will wait for either authentication or encryption keys to be revalidated. If this revalidation
fails, meaningful communication between master and slave radios will not be possible.
Use the no form of the commands to turn privacy options off.
NoteThese parameters can only be changed when the radio link is down (shut).
Unless an error occurs, no notifications are displayed on the console.
radio privacy enable
radio privacy auth-wait-time <secs>
radio privacy reauth-wait-time <secs>
module <{codec | fir | if | rf | framer}>
slot Positive integer representing the CiscouBR7200 series slot number.
port Positive integer representing the port number on that slot.