Installation Manual

CiscouBR7200 Series Universal Broadband Router Wireless Modem Card and Subsystem Installation and Configuration 77
led
ALPHA DRAFT - CISCO CONFIDENTIAL
Example
The following command will display the performance of the link since power-on.
WMCS01(boot)(config-if)# show interface radio 3/0 linkMetrics
led
Use this command to manually highlight specific conditions on a specified modem card using the
four LEDs on the card. Privileged configuration access is required.
Use the no form of the command to reset the settings of the LED to the default values.
Use the show interface <slot/port> form of the command to display the current configuration and
the state of the LEDS.
Unless an error occurs, no notifications are displayed on the console.
radio led <{<latchLeds><latchLedOptions> | <otherLeds><otherLedOptions>}>
no radio led <{latchLeds | otherLeds}>
show interface radio <slot/port> led
1TickCorrectedSyncByteErrs The sum of the total number of sync byte errors that were corrected over
the last 1 hardware tick and the previous 1 tick entry.
1TickConsecutiveCwErrs The sum of the total number of consecutive codeword errors received over
the last 1 hardware tick and the previous 1 tick entry.