Installation Manual

78CiscouBR7200 Series Universal Broadband Router Wireless Modem Card and Subsystem Installation and Configuration
Configuring a Wireless Modem Card
ALPHA DRAFT - CISCO CONFIDENTIAL
Syntax Description
Example
The following command sets the behavior of the major alarm LED to be controlled by the system at
all times.
WMCS01(boot)(config-if)# radio led major_alarm_led automatic
image-override
Use this command to attach a specified image file name to a specified chip. When an image has to
be downloaded to this chip, the configuration matching logic is ignored and the currently attached
image is downloaded. Privileged configuration access is required.
Use the no form of the command to remove the override.
Unless an error occurs, no notifications are displayed on the console.
latchLeds <{major_alarm_led | minor_alarm_led}>
major_alarm_led Indicates the occurrence of a major alarm in the radio subsystem. This LED can be
configured to be automatic or latched.
minor_alarm_led Indicates the occurrence of a minor alarm in the radio subsystem. This LED can be
configured to be automatic or latched.
latchLedOptions <{automatic | latch | off | solidGreen | solidYellow | blinkGreen | blinkYellow |
blinkBoth}>
automatic The system controls the behavior of the LED at all times.
latch The system will turn the LED on indicating an alarm condition; the operator must
turn it off. The operator can control the color that the LED will display when it is
turned on.
off This forces the LED to turn off.
solidGreen When the LED is turned on, it will be green in color.
solidYellow When the LED is turned on, it will be yellow in color.
blinkGreen When the LED needs to be turned on, it will blink green.
blinkYellow When the LED needs to be turned on, it will blink yellow.
blinkBoth When the LED needs to be turned on, it will blink alternately yellow and green.
otherLeds <{carrier_led | service_led}>
carrier_led Represents the state of the radio link. This LED cannot be latched, but the operator
can turn these LEDs on or off manually.
service_led Indicates the service availability on this radio link. This LED cannot be latched, but
the operator can turn these LEDs on or off manually.
otherLedOptions <{off | solidGreen | solidYellow | blinkGreen | blinkYellow | blinkBoth}>