Installation Manual

CiscouBR7200 Series Universal Broadband Router Wireless Modem Card and Subsystem Installation and Configuration 79
show interface (image-override)
ALPHA DRAFT - CISCO CONFIDENTIAL
radio image_override <chipName><image>
no radio dbg image_override
Syntax Description
Example
(explanation of example here)
WMCS01(boot)(config-if)# radio image_override TBD
show interface (image-override)
Use this command to display a list of chips and their associated overridden images.
Unless an error occurs, no notifications are displayed on the console.
show interface radio <slot>/<port> image-override
Syntax Description
Example
The following command will display the list of chips and associated overridden images for the
modem card in slot 3, port 0 of the uBR.
WMCS01(boot)(config-if)# show interface radio 3/0 image-override
dsp1a: ftp://222.33.33.44/myDspImages/test1.img
dsp2b: ftp://222.33.33.44/myDspImages/test2.img
snapshot
A snapshot is a specified amount of data captured from the modem card. Use these commands to
manipulate snapshots on the modem card. Privileged configuration access is required.
Use the radio snapshot command to create a snapshot specification. When this command is issued,
the specification is created and the data is captured.
chipName A character string identifying a chip.
image <protocol>://<host>/<directory>/<filename>
protocol < mem | tftp | flash}>
host IP Address.
directory Directory name. (No embedded spaces accepted.)
filename Name of image file.
slot Positive integer representing the CiscouBR7200 series slot number.
port Positive integer representing the port number on that slot.