Installation Manual

80CiscouBR7200 Series Universal Broadband Router Wireless Modem Card and Subsystem Installation and Configuration
Configuring a Wireless Modem Card
ALPHA DRAFT - CISCO CONFIDENTIAL
Use the no form of the command to delete a specification and its associated data.
Use the show interface radio snapshot command to display the configured snapshot information.
Use the show interface radio snapdata command to display the data captured for the snapshot
specification.
Use the radio interface radio snapcapture command to capture another snapshot on the identified
DSP. The snapshot specification already configured on the DSP will be used.
Use the radio interface radio snapclear command to clear the data collected for the specified
snapshot on the identified DSP.
Up to four different snapshot types can be requested at once. When more than one snapshot is
requested in a command, all of them will be initiated on the same DSP.
radio snapshot <dspId> <snapshotType>
no radio snapshot <dspId> <snapshotType>
show interface radio <slot>/<port> <{snapshot | snapdata}> <dspId>
radio interface radio <slot>/<port> snapcapture <dspId>
radio interface radio <slot>/<port> snapclear <dspId>