Installation Manual

CiscouBR7200 Series Universal Broadband Router Wireless Modem Card and Subsystem Installation and Configuration 83
scope-output
ALPHA DRAFT - CISCO CONFIDENTIAL
Example
(explanation of example here)
WMCS01(boot)(config-if)# radio snapshot TBD
scope-output
Use this command to configure a single DSP to send the identified type of output to the serial port.
An oscilloscope can be connected to the serial port to analyze the output of the DSP. Privileged
configuration access is required.
Use the no form of the command to turn off the serial output.
Use the show interfaces radio <slot>/<port> scope-output command to display the attribute being
directed to the scope port.
radio scope-output <dspId> <outputType>
no radio scope-output <dspId>
show interfaces radio <slot>/<port> scope-output
Syntax Description
Example
The following command configures DSP dsprxla to send output of type
rx-timedomainchannel-ant2-h2n to the serial port.
WMCS01(boot)(config-if)# radio scope-output dsprxla RxTimeDomainChannelant2H2n
sync-fll-fft-spectrum (0x20000) Represents a snapshot of Frequency locked loop, FFT
Spectrum. For every sample, the real and imaginary
components are captured.
Units: (I, q)
Value: 32 bit quantities
dspId <{dsprxla Receive DSP 1a | dsprx1b Receive DSP 1b | dsprx2a Receive DSP 2a | dsprx2b
Receive DSP 2b | dsprx3a Receive DSP 3a | dsprx3b Receive DSP 3b |
dsptx1 Transmit DSP 1 | dsptx2 Transmit DSP 2}>
outputType <{rx-rawburst-ant1-y1n | rx-rawburst-ant1-y2n | rx-spectrum-ant1-y1k |
rx-spectrum-ant1-y2k | rx-timedomainchannel-ant1-h1n | rx-timedomainchannel-ant2-h2n |
rx-freqdomainchannel-ant1-h1k | rx-freqdomainchannel-ant2-h2k | rx-constellation-zhatk |
tx-codec-input | tx-ifft-input | tx-round-output | sync-burst-timecost-func |
sync-freq-offset-costfunc | sync-pwrsbtcffocf | sync-fll-freq-corelation |
sync-fll-train-tone-corelation | sync-fll-fft-spectrum}>
slot Positive integer representing the CiscouBR7200 series slot number.
port Positive integer representing the port number on that slot.