User's Manual

38-97
Catalyst 3750 Switch Software Configuration Guide
OL-8550-09
Chapter 38 Configuring IP Unicast Routing
Configuring Protocol-Independent Features
To delete an entry, use the no route-map map tag global configuration command or the no match or no
set route-map configuration commands.
You can distribute routes from one routing domain into another and control route distribution.
Beginning in privileged EXEC mode, follow these steps to control route redistribution. Note that the
keywords are the same as defined in the previous procedure.
Step 18
set metric bandwidth delay reliability loading mtu Set the metric value to give the redistributed routes (for
EIGRP only):
• bandwidth—Metric value or IGRP bandwidth of the
route in kilobits per second in the range 0 to
4294967295
• delay—Route delay in tens of microseconds in the
range 0 to 4294967295.
• reliability—Likelihood of successful packet
transmission expressed as a number between 0 and
255, where 255 means 100 percent reliability and 0
means no reliability.
• loading— Effective bandwidth of the route expressed
as a number from 0 to 255 (255 is 100 percent
loading).
• mtu—Minimum maximum transmission unit (MTU)
size of the route in bytes in the range 0 to
4294967295.
Step 19
set metric-type {type-1 | type-2} Set the OSPF external metric type for redistributed routes.
Step 20
set metric-type internal Set the multi-exit discriminator (MED) value on prefixes
advertised to external BGP neighbor to match the IGP
metric of the next hop.
Step 21
set weight Set the BGP weight for the routing table. The value can
be from 1 to 65535.
Step 22
end Return to privileged EXEC mode.
Step 23
show route-map Display all route maps configured or only the one
specified to verify configuration.
Step 24
copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
router {bgp | rip | ospf | eigrp} Enter router configuration mode.
Step 3
redistribute protocol [process-id] {level-1 | level-1-2 |
level-2} [metric metric-value] [metric-type type-value]
[match internal | external type-value] [tag tag-value]
[route-map map-tag] [weight weight] [subnets]
Redistribute routes from one routing protocol to
another routing protocol. If no route-maps are
specified, all routes are redistributed. If the keyword
route-map is specified with no map-tag, no routes are
distributed.