Switch User Manual

22-29
Cisco ONS 15454 Procedure Guide, R7.0
November 2007
Chapter 22 DLPs A500 to A599
DLP- A530 Install the Tie-Down Bar
Step 1 Double-click the Ethernet card where you want to delete the RMON alarm thresholds.
Step 2 In card view, click the Provisioning > Ether Ports > RMON Thresholds tabs.
Note For the CE-Series, click the Provisioning > Ether Ports > RMON Thresholds tabs or
Provisioning > POS Ports > RMON Thresholds tabs.
Step 3 Click the RMON alarm threshold you want to delete.
Step 4 Click Delete. The Delete Threshold dialog box appears.
Step 5 Click Yes to delete the threshold.
Step 6 Return to your originating procedure (NTP).
DLP-A530 Install the Tie-Down Bar
Step 1 Align the ends of the tie-down bar with the four screw holes located 1 RU below the ONS 15454.
Figure 22-8 shows the tie-down bar, the ONS 15454, and the rack.
Purpose This task installs the tie-down bar used to secure cabling on the rear of the
ONS 15454. The tie-down bar can be used to provide a diverse path for
redundant power feeds and cables.
Tools/Equipment Tie-down bar
Screws (4)
Prerequisite Procedures DLP-A5 Mount the Shelf Assembly in a Rack (One Person), page 17-5
DLP-A6 Mount the Shelf Assembly in a Rack (Two People), page 17-6
Required/As Needed As needed
Onsite/Remote Onsite
Security Level None