Switch User Manual

22-44
Cisco ONS 15454 Procedure Guide, R7.0
November 2007
Chapter 22 DLPs A500 to A599
DLP- A537 Remove a Static TID to NSAP Entry from the TARP Data Cache
DLP-A537 Remove a Static TID to NSAP Entry from the TARP Data Cache
Step 1 In node view, click the Provisioning > OSI > TARP > Static TDC tabs.
Step 2 Click the static entry that you want to delete.
Step 3 Click Delete Static Entry.
Step 4 In the Delete TDC Entry dialog box, click Ye s.
Step 5 Return to your originating procedure (NTP).
DLP-A538 Add a TARP Manual Adjacency Table Entry
Step 1 In the node view, click the Provisioning > OSI > TARP > MAT tabs.
Step 2 Click Add.
Step 3 In the Add TARP Manual Adjacency Table Entry dialog box, enter the following:
• Level—Sets the TARP Type Code that will be sent:
– Level 1—Indicates that the adjacency is within the same area as the current node. The entry
generates Type 1 PDUs.
– Level 2—Indicates that the adjacency is in a different area than the current node. The entry
generates Type 2 PDUs.
• NSAP—Enter the OSI NSAP address in the NSAP field or, if preferred, click Use Mask and enter
the address in the Masked NSAP Entry dialog box.
Purpose This task removes a static TID to NSAP entry from the TDC.
Tools/Equipment None
Prerequisite procedures DLP-A60 Log into CTC, page 17-69
Required/As needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioner or higher
Purpose This task adds an entry to the TARP manual adjacency table (MAT). Entries
are added to the MAT when the ONS 15454 must communicate across
routers or non-SONET NEs that lack TARP capability.
Tools/Equipment None
Prerequisite procedures DLP-A60 Log into CTC, page 17-69
Required/As needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher