Switch User Manual

22-51
Cisco ONS 15454 Procedure Guide, R7.0
November 2007
Chapter 22 DLPs A500 to A599
DLP- A545 Edit the OSI Router Configuration
DLP-A545 Edit the OSI Router Configuration
Step 1 In node view, click the Provisioning > OSI > Routers > Setup tabs.
Step 2 Chose the router you want provision and click Edit.
Step 3 In the OSI Router Editor dialog box:
a. Check or uncheck the Enabled box to enable or disable the router.
Note Router 1 must be enabled before you can enable Routers 2 and 3.
b. For enabled routers, edit the primary area address, if needed. The address can be between
8 and 24 alphanumeric characters in length.
c. If you want to add or edit an area address to the primary area, enter the address at the bottom of the
Multiple Area Addresses area. The area address can be 2 to 26 numeric characters (0–9) in length.
Click Add.
d. Click OK.
Step 4 Return to your originating procedure (NTP).
DLP-A546 Edit the OSI Subnetwork Point of Attachment
Step 1 In node view, click the Provisioning > OSI > Routers > Subnet tabs.
Purpose This task allows you to edit the OSI router configuration, including
enabling and disabling OSI routers, editing the primary area address, and
creating or editing additional area addresses.
Tools/Equipment None
Prerequisite procedures DLP-A60 Log into CTC, page 17-69
Required/As needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task allows you to view and edit the OSI subnetwork point of
attachment parameters. The parameters are initially provisioned when you
create a Section DCC (SDCC), Line DCC (LDCC), generic
communications channel (GCC), or optical service channel (OSC), or when
you enable the LAN subnet.
Tools/Equipment None
Prerequisite procedures DLP-A60 Log into CTC, page 17-69
Required/As needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher