Switch User Manual

22-54
Cisco ONS 15454 Procedure Guide, R7.0
November 2007
Chapter 22 DLPs A500 to A599
DLP- A549 View IS-IS Routing Information Base
DLP-A549 View IS-IS Routing Information Base
Step 1 In the node view, click the Maintenance > OSI > IS-IS RIB tabs.
Step 2 View the following RIB information for Router 1:
• Subnet Type—Indicates the OSI subnetwork point of attachment type used to access the destination
address. Subnet types include SDCC, LDCC, GCC, OSC, and LAN.
• Location—Indicates the OSI subnetwork point of attachment. For DCC subnets, the slot and port
are displayed. LAN subnets are shown as LAN.
• Destination Address—The destination NSAP (network service access point) of the IS.
• MAC Address—For destination NEs that are accessed by LAN subnets, the NE’s Media Access
Control address.
Step 3 If additional routers are enabled, you can view their RIBs by choosing the router number in the Router
field and clicking Refresh.
Step 4 Return to your originating procedure (NTP).
Purpose This task allows you to view the Intermediate System to Intermediate
System (IS-IS) protocol routing information base (RIB). IS-IS is an OSI
routing protocol that floods the network with information about NEs on the
network. Each NE uses the information to build a complete and consistent
picture of a network topology. The IS-IS RIB shows the network view from
the perspective of the IS node.
Tools/Equipment None
Prerequisite procedures DLP-A60 Log into CTC, page 17-69
Required/As needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher