Switch User Manual

22-6
Cisco ONS 15454 Procedure Guide, R7.0
November 2007
Chapter 22 DLPs A500 to A599
DLP- A513 Provision CE-100T-8 Ethernet Ports
In the TCC CORBA (IIOP/SSLIOP) Listener Port area, choose a listener port option:
• Default - TCC Fixed—Uses Port 57790 to connect to ONS 15454s on the same side of the firewall
or if no firewall is used (default). This option can be used for access through a firewall if Port 57790
is open.
• Standard Constant—Uses Port 683 (IIOP) or Port 684 (SSLIOP), the Common Object Request
Broker Architecture (CORBA) default port number.
• Other Constant—If the default port is not used, type the Internet Inter-ORB Protocol (IIOP) or
SSLIOP port specified by your firewall administrator.
Step 8 In the SNMP Access area, set the Simple Network Management Protocol (SNMP) access state to
Non-Secure or Disabled (disables SNMP access).
Step 9 Click Apply.
Step 10 Return to your originating procedure (NTP).
DLP-A513 Provision CE-100T-8 Ethernet Ports
Note You can provision SONET contiguous concatenated (CCAT) or virtual concatenated (VCAT) circuits for
the CE-100T-8 before or after provisioning the card’s Ethernet ports and/or packet-over-SONET (POS)
ports. See the “NTP-A257 Create an Automatically Routed Optical Circuit” procedure on page 6-38 or
the “NTP-A264 Create an Automatically Routed VCAT Circuit” procedure on page 6-82, as needed.
Step 1 In node view, double-click the CE-100T-8 card graphic to open the card.
Step 2 Click the Provisioning > Ether Ports tabs.
Step 3 For each CE-100T-8 port, provision the following parameters:
• Port Name—If you want to label the port, enter the port name.
• Admin State—Choose IS to put the port in service.
• Expected Speed—Choose the expected speed of the device that is or will be attached to the Ethernet
port. If you know the speed, choose 100 Mbps or 10 Mbps to match the attached device. If you do
not know the speed, choosing Auto enables autonegotiation for the speed of the port, and the
CE-100T-8 port will attempt to negotiate a mutually acceptable speed with the attached device.
• Expected Duplex—Choose the expected duplex of the device that is or will be attached to the
Ethernet port. If you know the duplex, choose Full or Half to match the attached device. If you do
not know the duplex, choosing Auto enables autonegotiation for the duplex of the port, and the
CE-100T-8 port will attempt to negotiate a mutually acceptable duplex with the attached device.
Purpose This task provisions CE-100T-8 Ethernet ports to carry traffic.
Tools/Equipment None
Prerequisite Procedures DLP-A60 Log into CTC, page 17-69
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher