user manual

3-6

Cisco AVS 3180 Management Station Hardware Installation Guide

78-17292-01

Chapter 3 Installing the AVS 3180

Installing Your AVS 3180

4. Select a location in the rack to mount the AVS 3180, and attach the front end of the right outer

telescopic rail to the right side of the rack, as show in Figure 3-4.

Note Racks that contain tapped mounting holes do not require the cage nuts (3) that are shown in

Figure 3-4.

Figure 3-4 Attaching Front Rail to the Right Side of the Rack

5. Extend the middle rail from the front of the rack to allow free access to the two adjustment screws

located at the rear of the outer telescopic rail (Figure 3-5). Loosen the two adjustment screws to

leave some play when attaching the back end of the outer telescopic rail to the rack, and then push

the middle rail back into its original position. After the rail is attached to the rack, you can tighten

the two adjustment screws.

1 Round head screw and washer 3 Cage nut

2 Right outer telescopic rail—front

119962