User's Manual

5
Back Panel
Reset There are two ways to reset the Router’s settings to factory defaults.
Either press and hold the Reset button for approximately ten seconds, or
restore the defaults from the Administration > Factory Defaults screen of
the Router’s web-based utility.
Note: The reset does not restore the voice settings to the factory defaults.
WPS Text TBD
USB The USB port connects to a USB storage device, such as a USB hard drive
or flash disk.
Ethernet These Ethernet ports (1, 2, 3, 4) connect the Router to wired computers
LAN 1-4 and other Ethernet network devices.
F Connector Text TBD
Ethernet The WAN/LAN5 port can act as a Wide Area Network (WAN) or Local Area
WAN/LAN5 Network (LAN) port. As a WAN port, it connects to a broadband modem.
As a LAN port, it connects to a wired computer or other Ethernet network
device.
Connecting to the Network
1. Use a coaxial cable to connect the F-Conn port on the RMN302 to the
wall connector or to the coaxial network used to distribute IP data.
2. Use an Ethernet cable to connect the LAN port on the RMN302 to your
home network or to a PC.
3. Attach the power adapter to the POWER port on the back of the
RMN302, and plug it into a wall outlet.
4. Turn on the power switch.
FPO
T14758
FPO
PC or
Home Network
Coaxial Network Set-Top Box
To Wall
Outlet
V
O
L
U
M
E
C
H
A
N
N
E
L
TV Guide Record
CISCO 8455DVB
DRAFT - 6/25/201
0