User's Manual

QoS (Quality of Service)

• Enable To enable this QoS rule, select the check box. Otherwise, leave the check box

blank.

• Classification Sources Select All Sources, Local Router, All LAN Ports that traffic

will come from, or a specific LAN port: Ethernet Ports 1-5 or WLAN SSID networks. The

default is All Sources.

• Ethernet Type Select None, IP (0x0800), ARP (0x0806), PPPoE Discovery Stage

(0x8863), PPPoE Session State (0x8864), or EAPOL (0x888e).

• Protocol If you selected IP (0x0800) for the Ethernet Type setting, then select the

appropriate Protocol: None, ICMP (1), IGMP (2), TCP (6), or UDP (17).

Depending on the Protocol you selected, the following settings may be available:

• Destination IP Enter the Destination IP address, if applicable as a filter condition.

• Destination Subnet Mask Enter the Destination subnet mask, if applicable as a filter

condition.

• Destination Port If you selected TCP or UDP for the Protocol setting, enter the

Destination port range, if applicable as a filter condition.

• Source IP Enter the Source IP address of the local computer, if applicable as a filter

condition.

• Source Subnet Mask Enter the Source subnet mask, if applicable as a filter condition.

• Source Port If you selected TCP or UDP for the Protocol setting, enter the Source port

range, if applicable as a filter condition.

• Source MAC Enter the Source MAC address of the local computer, if applicable as a filter

condition.

• Source MAC Mask Enter the Source MAC Mask, if applicable as a filter condition. If you

leave this setting blank, then this mask will be ignored.

• Source Vendor Class ID If applicable as a filter condition, enter the Source Vendor Class ID

in the host’s DHCP request.

• Source Client ID If applicable as a filter condition, enter the Source Client ID in the host’s

DHCP request.

•

Source User Class ID If applicable as a filter condition, enter the Source User Class ID in the

host’s DHCP request.

• DSCP If applicable as a filter condition, enter the DSCP value of the LAN’s incoming packet.

• Ethernet Priority If applicable as a filter condition, enter the Ethernet Priority of the LAN’s

incoming packet.

• VLAN ID If applicable as a filter condition, enter the VLAN ID of the LAN’s incoming packet.

• Ethernet Priority Mark (optional) To mark outgoing packets with a specific 802.1p value,

enter the value in the field provided.

• DSCP Mark (optional) To mark outgoing packets with a specific DSCP value, enter the value

in the field provided.

• Target Interface (optional) All WAN connections and PVC/VLAN bridges are listed. Select

the appropriate interface. The Router will direct matching packets to this outgoing interface.

QoS > Add New Rule

DRAFT - 6/25/201