User's Manual

CLANDEV: One or more LAN devices are attached and active.

CLANBW: Both the delta number of bytes sent and the number of bytes received are

greater than the LAN bandwidth threshold.

CBHR_CPU: The CPU utilization is less than the CPU threshold.

CWANMOCA_PORT: The physical MoCA port is operational with no hardware failure.

CWANETH_PORT: The Ethernet port is operational, with no hardware failure.

CWANIPCON_PNGDF: The default gateway responds to to the ICMP PING.

CWANIPCON_DNSR: The DNS server responds to ICMP PING.

CLANTYPE: One or more of the LAN interface are enabled (LAN MoCA, LAN Ethernet, and

LAN WiFi).

CLANMOCA_RATE: Both transmission rates (Tx and Rx) are greater than the MoCA rate

threshold.

CLANWIFI_PORT: The WiFi interface is operating optimally, with no hardware issues or

errors.

CLANIP: All LAN devices have an IP address assigned.

CLANIPCONSTB_PNG: All attached and active set-top boxes respond to the ICMP PING.

Administration > Backup

The Backup screen allows you to back up or restore the Router’s settings using a configuration

file.

Backup Configuration

Backup To save the Router’s settings in a configuration file, click this button and follow the

on-screen instructions.

Note: The voice settings will not be saved in the configuration file.

Restore Configuration

To use this option, you must have previously backed up its configuration settings.

Please select a file to restore Click Browse and select the Router’s configuration file.

Restore To restore the Router’s configuration settings, click this button and follow the

on-screen instructions.

Administration > Factory Defaults

The Factory Defaults screen allows you to restore the Router’s configuration to its factory

default settings, except for the voice settings. (An alternative method is to press and hold

the Reset button on the Router’s back panel for approximately ten seconds.)

Note: Restoring factory defaults deletes custom settings except for the voice settings.

Note your custom settings before clicking the Restore Factory Defaults button.

Administration > Factory Defaults

Administration > Backup

DRAFT - 6/25/201