User manual

4035197 Rev C D9865 Satellite Receiver Installation and Operation Guide 5-29
Configuring the Common Interface (CI) Information, Continued
5. In the CA List Management Type drop-down list, select AddDel (Default) to
add or delete programs individually in the CAM. Set to Update All to
automatically update and reset all the programs each time you add or modify
the programs available via the CAM.
6. Select Enable in the TS/ONID Check drop-down list if you want to restrict the
incoming transport stream to the transport ID and transport original network ID
listed below. If the incoming stream does not match the specified transport
stream, the CAM will not decrypt. The default is Disable.
7. Set the Transport ID and Original Network ID if you had set the TS/ONID
Check to Enable. If the incoming stream does not match the specified IDs here,
the CAM will not decrypt. You can enter a value in the range from 0 to 65535.
8. If you selected Comp as the Decryption Mode, you can insert and maintain
customized records in the CI Component Setup section. Each record customizes
the PID or stream type to decrypt. The Index number is a read only field that
indicates the record number. You can maintain up to 32 records.
To insert a new record, click Add. A new row appears at the top of the table (see
below).
There are various configurations when creating a new record.
The following table summarizes the various methods:
If you set by Parameter Settings
PID Set Mode to PID and enter PID number.
New Record