User manual

C-1
Installation Guide for Cisco Unity Release 5.x with IBM Lotus Domino (Without Failover)
OL-13599-01
APPENDIX
C
Installing and Configuring a Voice-Recognition
Server
Use the following task list to install and configure voice-recognition software on a separate
voice-recognition server. The tasks reference detailed instructions in the Cisco
Unity installation guide
as noted. Follow the documentation for a successful installation.
This appendix assumes that the Cisco Unity license includes voice recognition and that you are installing
and configuring a voice-recognition server for a new Cisco
Unity system. If you are adding a
voice-recognition server to an existing Cisco
Unity system, see the “Adding Voice Recognition” section
in the “Adding Features to the Cisco
Unity 5.x System” chapter in the applicable Reconfiguration and
Upgrade Guide for Cisco
Unity at
http://www.cisco.com/en/US/products/sw/voicesw/ps2237/prod_installation_guides_list.html.
1. Place the voice-recognition server in a dry, cool area that is free of dust and that is near a network
connection.
2. Attach any supported peripheral devices to the server. Follow the manufacturer installation and test
instructions.
3. If you are installing Windows Server 2003 using a retail Windows disk, configure the RAID arrays.
See the
“Configuring the RAID Arrays (Selected Installations)” section on page 4-3.
4. Install and configure Windows Server 2003 using the applicable procedure:
• If you bought the Cisco Unity server from Cisco: See “Installing Windows Server 2003 by
Using the Cisco Unity Platform Configuration Discs” section on page 4-4.
• If you bought the Cisco Unity server from another vendor: See “Installing Windows
Server 2003 by Using a Retail Windows Server 2003 Disc” section on page 4-8.
Caution Cisco Unity voice-recognition software cannot be installed on a server running
Windows 2000 Server.
5. If you installed Windows Server 2003 using a retail Windows disc: Create the partitions according
to the storage configuration requirements for the platform. See the
“Creating the Partition” section
on page C-2.
6. Install the required Windows service pack and updates and, optionally, Cisco Security Agent for
Cisco
Unity. See the “Installing the Required Windows Server 2003 Service Pack and Updates, and
Cisco Security Agent for Cisco Unity” section on page C-3.
7. If the Cisco Unity server contains a dual NIC: Configure the dual NIC or verify the configuration.
See the
“Configuring a Dual NIC in the Cisco Unity Server” section on page 5-2.