User's Manual
Table Of Contents
- 78-20139-01.JAB.cn
- Before You Begin
- Product Features
- Connecting the Equipment
- Configuration and Management of the ATA
- Registering a Cisco SPA302D Handset
- Additional Information
- Where to Go From Here
- Avant de commencer
- Fonctions du produit
- Connexion de l'équipement
- Configuration et gestion de l'adaptateur de terminal analogique
- Enregistrement d'un combiné Cisco SPA302D
- Informations supplémentaires
- Problèmes et solutions
Cisco SPA232D Quick Start Guide 13
To mount the unit to the wall:
STEP 1 Determine where you want to mount the unit. Verify that the surface
is smooth, flat, dry, and sturdy.
STEP 2 Drill two pilot holes into the surface 58 mm apart (about 2.28 in.).
Make sure that the holes are at the same height above the floor so
that the unit is level and secure in either of its two safety-certified
orientations.
STEP 3 Insert a screw into each hole, leaving a gap of 5 mm (0.1968 in.)
between the underside of each screw head and the surface of the
wall.
STEP 4 Place the unit wall-mount slots over the screws and slide the unit
down until the screws fit snugly into the wall-mount slots.