User's Manual
Table Of Contents
- 78-20139-01.JAB.cn
- Before You Begin
- Product Features
- Connecting the Equipment
- Configuration and Management of the ATA
- Registering a Cisco SPA302D Handset
- Additional Information
- Where to Go From Here
- Avant de commencer
- Fonctions du produit
- Connexion de l'équipement
- Configuration et gestion de l'adaptateur de terminal analogique
- Enregistrement d'un combiné Cisco SPA302D
- Informations supplémentaires
- Problèmes et solutions
2 Cisco SPA232D Quick Start Guide
Welcome
Thank you for choosing a Cisco SPA232D Mobility Enhanced ATA.
This guide describes how to physically install the equipment and how to
get started configuring the ATA.
This guide also explains how to register a Cisco SPA302D Mobility
Enhanced Cordless Handset with the Cisco SPA232D, which has an
integrated DECT Base Station. Cisco SPA302D handsets registered to the
Cisco SPA232D can make and receive calls through a Voice over IP (VoIP)
service provider and through the local telephone system (via the LINE
port). Only Cisco SPA302D handsets are supported with the Cisco
SPA232D.
Before You Begin
Before you begin the installation, make sure that you have the following
equipment and services:
• An active Internet account and Voice over IP account
• Ethernet cable to connect to your broadband network device
• Phone to connect to your ATA
• Phone cable to connect your phone
• Optional: Uninterruptible Power Supply (UPS) to provide backup power
• Optional: Cisco SPA302D Mobility Enhanced Cordless Handsets
1