User's Manual

6 Cisco SPA232D Quick Start Guide
Configuration and Management of the ATA
You can use the web-based configuration utility to set up your ATA. You
also can use the built-in Interactive Voice Response (IVR) system. (See
Using the IVR for Administration, page 8.)
STEP 1 Connect the provided Ethernet network cable to the ETHERNET
(Yellow) port of the ATA. Connect the other end of the cable to the
Ethernet port of your PC.
STEP 2 Power on your computer.
NOTE: Make sure your computer’s Ethernet adapter is set to obtain
an IP address automatically (DHCP). For more information, refer to
the Help for your operating system.
STEP 3 Start a web browser on your computer.
STEP 4 In the Address bar, enter: 192.168.15.1
Note: 192.168.15.1 is the default local IP address of the ATA.
STEP 5 To log in for the first time, enter the default username, admin, and
the default password, admin. The password is case sensitive.
NOTE: A user account allows access to limited settings and status
pages. To log in as a user, enter cisco as the username and the
password.
STEP 6 Use the Quick Setup page as needed to register your VoIP
accounts in the fields for Line 1 and DECT Line1.
Your VoIP service may require only a few basic parameters to
successfully register the Cisco SPA232D. The Quick Setup page
offers a shortcut to enter the basic parameters. For a more
comprehensive listing of parameters, choose the Voice menu, and
then use the links in the navigation tree.
•Enter Proxy: Enter the domain name or URL of the service
provider’s proxy server.
•Display Name: Enter the name of the business. This name
typically is used for the Caller ID.
•User ID: Enter the user ID for your Internet account with this
service provider.
•Password: Enter the password for your Internet account.
• Dial Plan (Line 1 only): Keep the default settings
(recommended). Detailed information about the dial plan
settings is available in the online Help and the administration
guide.
4