User's Manual

Cisco SPA232D Quick Start Guide 7
Note: The Cisco SPA232D assigns DECT Line1 as the default line
for outgoing calls from Cisco SPA302D handsets. If needed, you
can configure additional VoIP accounts as separate “DECT Lines.”
To do so, choose the Voice menu, and then use the DECT Line
1~10 links in the navigation tree. Use the check boxes on the Quick
Setup page to associate the DECT Line(s) to each handset.
STEP 7 Click Submit to save your settings.
STEP 8 If you wish to change the PIN for handset registration, open the
Voice > System page, and then enter up to four digits in the IVR
Admin Password field. Click Submit to save your settings.
For more information, see the online Help or the administration guide.
(Documentation links are provided in Where to Go From Here, page 14.)
Registering a Cisco SPA302D Handset
You can register Cisco SPA302D handsets to the integrated DECT base
station. These handsets can be purchased separately.
STEP 1 On the Cisco SPA302D handset, press the center Select button on
the 4-way navigation keypad.
STEP 2 Select Register.
STEP 3 Using the navigation arrows, scroll to the Settings icon
and press the center navigation button to select it.
STEP 4 Select Handset Registration.
STEP 5 On the Cisco SPA232D, press the Page/Registration button and
hold it down for at least seven seconds until the green status light
flashes quickly.
TIP: If you press the button for fewer than seven seconds, the
green status light flashes slowly, indicating the unit is in “paging”
mode and is not in registration mode. Registration will not work if
the unit is in paging mode.
STEP 6 The default PIN is blank, so do not enter a PIN. Press the left
softkey to confirm that you want to register the handset. The
“registering” message appears.
5