user manual

30-11
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-21521-01
Chapter 30 Configuring LLDP, LLDP-MED, and Wired Location Service
Monitoring and Maintaining LLDP, LLDP-MED, and Wired Location Service
This example shows how to enable NMSP on a switch and to set the location notification time to 10
seconds:
Switch(config)# nmsp enable
Switch(config)# nmsp notification
interval location 10
Monitoring and Maintaining LLDP, LLDP-MED, and Wired
Location Service
Command Description
clear lldp counters Reset the traffic counters to zero.
clear lldp table Delete the LLDP neighbor information table.
clear nmsp statistics Clear the NMSP statistic counters.
show lldp Display global information, such as frequency of transmissions, the holdtime for
p
ackets being sent, and the delay time before LLDP initializes on an interface.
show lldp entry
entry-name Display information about a specific neighbor.
You can enter an asterisk (*) to display all
neighbors, or you can enter the
neighbor name.
show lldp interface [in
terface-id] Display information about interfaces with LLDP enabled.
You can limit the display to a specific interface.
show lldp neighbors [in
terface-id]
[detail]
Display information about neighbors, including device type, interface type and
number, holdtime settings, capabilities, and port ID.
You can limit the display to neighbors of a specif
ic interface or expand the display
for more detailed information.
show lldp traffic Display LLDP counters, including the number of packets sent and received,
n
umber of packets discarded, and number of unrecognized TLVs.
show location Display the location informati
on for an endpoint.
show network-policy profile Display the configured network-policy profiles.
show nmsp Display the NMSP information.