System Manual

2-8
Cisco 860 Series, Cisco 880 Series, and Cisco 890 Series Integrated Services Routers Hardware Installation Guide
OL-16193-07
Chapter 2 Installing the Router
Installing the Router
Tip When choosing a location for wall-mounting the router, consider cable limitations and wall structure.
To mount the router on a wall, follow these steps:
Step 1 Determine the required distance between mounting holes on the router. Figure 2-4 shows the wall-mount
holes located on the underside of the router.
Note For most router models, the distance between mounting holes is 8.2 inches (208 mm), as shown
in
Figure 2-4. For the Cisco 866 and Cisco 867 models, the distance is 7.85 inches (199 mm).
Ver i f y t h e r e qu i r e d d i s ta nc e before drilling the holes.
Figure 2-4 Wall-mount Holes on the Underside of the Router
Step 2 Insert the screws, with anchors, into the wall. Leave 1/8 inch (0.32 cm) between the screw head and the
wall. See
Figure 2-5.
Step 3 Hang the router on the screws, and place the power adapter on a nearby horizontal surface. See
Figure 2-5.
1 Wall-mount holes
2
31987
1
3.673 in.8.200 in.
5.961 in.
1